JediMasterMark (Mark Jones)
Active Legion Member
Darth Maul reimagined as a Jedi
General in the Clone Wars
I spent a lot of time looking on the
SLD and studying the Maul images
there (for obvious reasons). After
making the first part of a mock-up,
however, it hit me that this was a
perfect CW Jedi General costume as
well. Why not let it be a part of the
Light Side? I used Doug
Barry’s hand drawn Maul Pepsi
measurements image (seen here:
m.jpg). From there I began to
pattern out the costume, softening
some of the angles while staying
true to the concept of the costume.
All parts were sewn/created by me
except where noted.
It consists of:
1. Kona Khaki sleeveless knee
length inner tunic. IT is split on the
side, single piece along the back.
The lapel has 4 stitches running
along it that tapers to a single line
after the join closed by invisible
2. Sand colored Linen Suiting
outer tunic. The tunic includes
quilted upper sleeves, knife pleated
(6 on each arm) lower sleeves and
divided in the back. A piece falls
across the back of it of the same
material (the rear has been made
longer now). The entire outer tunic
lined (except the sleeves).
3. Tabards – 2 sets. One crinkle
cotton 5 ½” wide set, lined, starts
belt and falls almost to knee length,
angled upwards out to in. One set of
crinkle cotton 5 ½” (double
thickness) wraps around
the neck scarf-style, drops down the
ends near front belt padding, angled
downwards out to in.
4. Inner belt – belt is leather half
hide, wrapped on cardboard for the
stiffness effect and glued down.
Across the inside is a strip of Velcro
which attaches the center front
tabbard, tapered as Maul's with a
slightly gentler curve.
5. Outer belt – OR Jedi standard
belt with 8 studs and silver buckle in
light red/brown tone.
6. Dark khaki pants.
7. Light red/brown boots, one
strap across bottom, three across
8. One set of silver food
9. Two pouches.
10. Covertec Clip
11. Jedi General armor from Erich.
Coated with base plastic primer,
white Krylon and covered with satin
finish. Attached to black Nomex
12. Blue double bladed lightsaber
(can be broken apart into 2) by
13. Large dark brown robe from
14. Horns were created with
Sculpey, baked and then coated in
Liquid Latex. Tattoo makeup by
EDIT: Upgraded OT to include
longer piece beneath the waist seam
to go to knee level. Upgraded horns
& makeup for full coverage.