Jedi Tunic and Inner Tunics
There are several alternatives for making a Jedi Tunic. If
you wish to use a commercial pattern, Simplicity 8311 is a good
choice. The only real modifications necessary would be lengthening
Using the Karate Gi for a pattern and making small modifications
is another option. That is the basis for the pattern below. This
pattern has been revised to reflect some suggestions made by "Got
Maul". Hopefully it is a bit more accurate.
If you are using a Gi in your size then measure it, if not
then use the measurements below
Remember to add 1/2" for seam allowance and hems
Be sure to add enough around the hips so it will fit well
as a Jedi tunic is not open at the bottom of each side like a
A = top of hand to top of hand
B = top of shoulder to mid thigh or desired length
C = measure hips at widest point and then add 3-4" for
a loose fit.
D = 18" at the shoulder then flaring out until 21"
at the wrist
1 - sew the two front panels to the back piece
Step 2 - fold the sleeves in half and then find the center
then attach each sleeve's center point to the shoulder seam (where
the front and back piece meet)
Step 3 - sew under arms and down the sides of the tunic
Step 4 - now take the trim piece and fold it in half down
the entire length using an iron to crease. Folding in the raw
edges of the trim fold it over the front panel piece and pin it
in place. Once it is pinned securely on both front panels and
the neck portion of the back piece, sew it into place. Hem the
sleeves bottom of the tunic.
Obi-Wan's Garb Details
I received an great email from Claude Marcotte pointing out
a couple of details about Obi-Wan's Tunic. Here's the info...
tunic has a lining on the inside. It allows the outer tunic's
sleeves to move about freely (otherwise the two fabrics will stick).
At a minimum, just line the sleeves." "The outer tunic
has a fold in the top of the shoulder...The outer tunic has a
lining on the inside. It allows the outer tunic's sleeves to move
about freely (otherwise the two fabrics will stick). At a minimum,
just line the sleeves."
An email I recieved from Lynn Duffield concerning Obi-Wan's
tunic details. "With
35+ years of sewing under my belt, I am afraid I have to disagree
with Claude Marcotte about Obi-Wan's tunic sleeves being lined.
In the pictures I have seen, you can clearly see the sleeve hem
on the outside of his sleeve. Traditionally, you would see a lined
sleeve like that on a suit jacket or coat. In tailoring, the right
side of the lining is attached to the right side of the sleeve
material and the sleeve is pressed up along the hem line enclosing
the seam. If you notice, the lining material seems to be a bit
longer than it needs to be where it is attached to the sleeve
material. This is ease and allows you to move without ripping
out the lining. However, you don't see a hem on the exterior of
your coat or jacket sleeve. I suppose you could turn the sleeve
fabric up and hand hem it to the lining material to achieve the
same effect, but in the pictures I have seen seem to show the
sleeve hem clearly on the exterior of Obi-Wan's sleeve. This would
mean that you are stitching through both the lining material and
the sleeve material. This also means that you have lost the ease
in the lining. But here is another question. In the attached picture
are Obi-Wan's sleeves stuck to his undertunic or did the costumers
put a tuck there too? "Help, my sleeves are too long!"
"We don't have time to re-hem them. We'll just take up a
little fabric..." Of course it is always possible that there
are two versions of the tunic - one lined, the other not - depending
on what was being filmed....."
Jedi Inner Tunic
Although we never get a good look at the inner tunic, from
the wrap of the neck line, we can assume that it is based on the
same pattern as the outer tunic. The only difference seems to
be in the sleeves. The inner tunic appears to have longer, more
fitted sleeves that bunch up at the wrist. To make the sleeve
modifications to your tunic pattern, measure your fist, and make
the sleeve at least that wide. Afterall you want it to be close
fitting but you will need it wide enough to fit your hand through.
Also lengthen the sleeve so that it will scrunch up a bit at the
"... I noticed a difference other than sleeves on the
inner tunic. Not only are the sleeves different, but the "Trim"
around the neck and front is smaller than the outter. On the inner
it appears to be 1" where on the outter it seems to be 1
1/2" - QuiGonSean
Here are a couple of pics that show the sleeve of the inner
The inner tunic seems to be made out of a lighter weight material.
For Obi-Wan I would recommend using a light weight linen or a
muslin. For Qui-Gon I would recommend rawsilk or silk noil. Use
whatever fabric works for you but try to stay away from synthetic
Synthetic fabric = Sauna!